ASQ CQI Actual Free Exam Questions & Community Discussion
Often inspection stations do not require full time presence. A usual practice is to collect such stations into a __________ so designed that it will occupy the full time of one person.
Response:
Response:
Correct Answer: A
Vote an answer
The p, np, u, and c control charts are referred to as:
Response:
Response:
Correct Answer: A
Vote an answer
When a control chart is used on a new process, capability can be assessed at which of the following times?
Response:
Response:
Correct Answer: B
Vote an answer
Which of the following resolutions would be used to verify a dimension of 1.5 mm 0.05 mm?
Response:
Response:
Correct Answer: C
Vote an answer
The area of a rectangle is 62.92 cm2. If two of its sides measure 5.2 cm, what is the length of the other two sides?
Response:
Response:
Correct Answer: B
Vote an answer
Flowcharts used during tracing strategies are useful in that they:
Response:
Response:
Correct Answer: C
Vote an answer
If the area of a rectangle is 483.6 square yards and one side is 93.6 feet long, what is the length, in feet, of the other side of the rectangle?
Response:
Response:
Correct Answer: A
Vote an answer
A bottle is received in a standard lot size of 100,000. Each lot received is sampled for visual inspection. The sample size is determined using ANSI/ASQC Z1.4-1993 and is 500 bottles. This is an example of which of the following?
Response:
Response:
Correct Answer: A
Vote an answer
A portion of units obtained from the same location in all containers, racks, bins, or dunnage illustrates which of the following?
Response:
Response:
Correct Answer: B
Vote an answer
Devise a sampling plan for obtaining a representative BTU sample from an open top railcar of coal, where the contents are known to have changed and also stratified due to vibration and exposure during the 10 days of shipment.
Response:
Response:
Correct Answer: D
Vote an answer
Which of the following is the maximum number of defective units or defects in a sample that will permit acceptance of the lot?
Response:
Response:
Correct Answer: C
Vote an answer
A gap analysis is performed to identify gaps between:
Response:
Response:
Correct Answer: D
Vote an answer
When constructing an ẍ and R chart, the 3ᶞ upper control limit for ẍ is calculated by the formula:
Response:
Response:
Correct Answer: D
Vote an answer
You are visiting a supplier of machined parts and are checking the calibration of their hand tools. You observe that their calibration technician is performing calibrations right on the production floor.
What can you conclude about these calibrations?
Response:
What can you conclude about these calibrations?
Response:
Correct Answer: C
Vote an answer
0
0
0
10