CWNP CWDP-304 Actual Free Exam Questions & Community Discussion
Before performing a pre-deployment passive RF survey of a new deployment using survey mapping software, which of the following must be performed?
Correct Answer: D
Vote an answer
As a device starts to shift to lower PHY rates, what factors usually influence a device decision to shift to lower PHY rates?(Choose all that apply.)
Correct Answer: A,B,C,D
Vote an answer
A museum wants to offer Wi-Fi to its visitors. One of their requirements is to have the APs blend into the design of the museum. What should you do to meet this requirement?
Correct Answer: D
Vote an answer
Excessive uplink RTP frame retransmissions can result in ____________.
Correct Answer: C
Vote an answer
What document is typically created to launch a project?
Response:
Response:
Correct Answer: D
Vote an answer
Switches and APs have already been chosen by your customer. All switches support 802.3bz MultiGig interfaces and APs are 4x4:4 802.11ac wave 2 capable of using dual-5GHz and have one MultiGig interface. Some cable drops for the APs will run for more than 180.5 feet (or 55 meters). To support MultiGig, what is the best choice of cabling?
Correct Answer: B
Vote an answer
As an implementation engineer, you have just received initial design specs from a network designer for your dual-band 802.11n deployment. The network design documents prescribe the following data rate configuration for the 2.4 GHz radio:
Basic Rates 5.5, 6, 11, 12 Mbps
Supported Rates 9, 18, 24, 36, 48, and 54 Mbps as well as MCS 0-15
What will result from this design strategy?
Basic Rates 5.5, 6, 11, 12 Mbps
Supported Rates 9, 18, 24, 36, 48, and 54 Mbps as well as MCS 0-15
What will result from this design strategy?
Correct Answer: C
Vote an answer
A controller-based WLAN infrastructure has its controller on a different subnet than its APs. What device must be used to enable any communication between the Controller and the APs?
Correct Answer: C
Vote an answer
Which operational plane would be responsible for performing automated RF management?
Response:
Response:
Correct Answer: E
Vote an answer
After designing a WLAN infrastructure using predictive design software. What's the best way to validate the predictive design in the physical space before deployment, if time and budget allow for it?
Correct Answer: C
Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
You performed a site survey with two USB Wi-Fi adapters using a special driver written for the site survey software. After deployment, you realized that the client devices used by your customer are getting lower RSSI values than that shown during your site survey. What is the most likely reason for this result?
Correct Answer: C
Vote an answer
0
0
0
10