Cisco 200-150 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 200-150
Exam Name/Title: Introducing Cisco Data Center Networking
Certification Provider: Cisco
Corresponding Certification: CCNA Data Center

Exam Questions: 175
Updated On: May 30, 2026

Question #46

On a Cisco Nexus switch, you need to configure an ACL that denies only SSH traffic from any source host
10.68.68.68. Which command should you use?

A. switch(config)# access-list 101 deny tcp any host 10.168.68.68 eq 22

B. switch(config)# access-list 101 deny tcp any host 10.168.68.68 eq 22 switch(config)# access-list 101 permit ip any any

C. switch(config)# access-list test
switch(config-acl)# deny tcp any host 10.168.68.68 eq 22 switch(config-acl)# permit ip any any

D. switch(config)# access-list test
switch(config-acl)# deny tcp any host 10.168.68.68 eq 22

Discussion 0

Correct Answer: C Vote an answer

Question #47

A network engineer examines a data capture and finds a lage amount of traffic with the destination address of FF:FF:FF:FF:FF:FF. What type of address is this?

A. Layer 3 broadcast address

B. a multicast address

C. Layer 2 broadcast address

D. Layer 3 network address

Discussion 0

Correct Answer: C Vote an answer

Question #48

Which route type is the most trustworthy for a Cisco routing device?

A. static

B. EIGRP dynamic

C. BGP dynamic

D. OSPF dynamic

Discussion 0

Correct Answer: A Vote an answer

Question #49

Which two protocols are associated with the link layer of the TCP/IP reference model? (Choose two.)

A. IPsec

B. HSRP

C. LLDP

D. UDP

E. STP

Discussion 0

Correct Answer: C,E Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #50

Which two aspects are characteristic of Fibre Channel WWNs? (Choose two.)

A. 48 bits long

B. allocated to manufacturers by IEEE

C. 64 or 128 bits long

D. manually configured on each device by an administrator

E. 96 bits long

Discussion 0

Correct Answer: B,C Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #51

Drag and drop the VPC components on the left to the correct descriptions on the right. Not all options are used.

Discussion 0

Correct Answer:

Question #52

Which two characteristics of IPv6 link local addresses are true? (Choose two.)

A. They must always start with FE80:1000:0000:0000

B. Forwarding scope is site local only.

C. unicast

D. multicast

E. Forwarding scope is link local only.

Discussion 0

Correct Answer: C,E Vote an answer

Question #53

What is a limitation of network-based IPS?

A. It is unable to monitor attacks across the entire network.

B. Large installations require numerous sensors to fully protect the network.

C. It must be individually configured to support every operating system on the network.

D. It is most effective at the individual host level.

Discussion 0

Correct Answer: B Vote an answer

Question #54

Drag and drop each zoning description on the left to the correct type of zoning on the right.

Discussion 0

Correct Answer:

Question #55

Which two protocols can you use for file-based storage? (Choose two.)

A. NFS

B. FCP

C. FCIP

D. CIFS

E. iSCSI

Discussion 0

Correct Answer: A,D Vote an answer

Question #56

How many Fibre Channel zone sets can be active at one time for any given VSAN?

A. 2

B. 4

C. 3

D. 1

Discussion 0

Correct Answer: D Vote an answer

Question #57

Which statement accurately describes the Single Initiator Single Target zone model?

A. One initiator HBA card connects to one disk controller.

B. One initiator node connects to one SAN fabric.

C. One initiator HBA port connects to one disk controller.

D. One initiator node connects to one SAN array.

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #58

Which statement about the HSRP protocol is true?

A. One router in an HSRP group is in an active state. All other routers are in a standby state or listening state.

B. In Cisco NX-OS, HSRP is configured to pre-empt by default.

C. HSRP version 2 is an open standard protocol that is described in RFC 2281.

D. Multiple routers in an HSRP group are in an active state, to enable round-robin load balancing of traffic.

Discussion 0

Correct Answer: A Vote an answer

Question #59

Which two protocols operate at the data link layer of the OSI reference model? (Choose two.)

A. LLDP

B. NetBIOS

C. OSPF

D. ICMP

E. STP

Discussion 0

Correct Answer: A,E Vote an answer

Question #60

What is the binary notation of the 192.168.3.24 IP address?

A. 10100000 10110010 11100011 00011001

B. 11000100 11101000 00000011 00010000

C. 11000000 11000001 11000101 11000111

D. 11000000 10101000 00000011 00011000

Discussion 0

Correct Answer: D Vote an answer

Download Free Cisco 200-150 Demo

Simply submit your e-mail address below to get started with our free demo of your Cisco 200-150 exam.