Cisco 300-365 Actual Free Exam Questions & Community Discussion
Refer to the exhibit.
A wireless tech must add an AP group mapping with the interface on VLAN 3 and the GUEST-DATA-SSID to the existing AP group "lobbyAPs". Which command makes this change?
A wireless tech must add an AP group mapping with the interface on VLAN 3 and the GUEST-DATA-SSID to the existing AP group "lobbyAPs". Which command makes this change?
Correct Answer: C
Vote an answer
A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented.
How should the engineer perform the password recovery?
How should the engineer perform the password recovery?
Correct Answer: A
Vote an answer
A sporting arena has a new wireless network and finds that clients are not connecting to their nearest access point. Which setting can be enabled to minimize this behavior and reduce the AP view of channel utilization?
Correct Answer: D
Vote an answer
A wireless engineer must design a wireless mesh network for the courtyard at a local university to support a large number ofstudents. Which description of how the engineer designs the mesh network to provide additional capacity is true?
Correct Answer: A
Vote an answer
Which is the recommended maximum number of hop counts to support data clients on a wireless indoor mesh network?
Correct Answer: C
Vote an answer
A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue?
Correct Answer: D
Vote an answer
A customer has configured a wireless LAN controller and set the 802.11a/n data rates. All rates are enabled where 5.5 Mbps, 11Mbps, and 24 Mbps are set to Mandatory. What will APs send over the 24 Mbps data rate?
Correct Answer: C
Vote an answer
A wireless printer has been configured with a static IP address. Which action does the Cisco WLC take in response?
Correct Answer: C
Vote an answer
When CAPWAP protocol runs over IPv4, which UDP port numbers are used for control and data traffic, respectively?
Correct Answer: A
Vote an answer
Which feature must be enabled on a WLC to ensure that ARP, DHCP, and data traffic can be forwarded to wired clients located behind non-Cisco workgroup bridges?
Correct Answer: A
Vote an answer
Which feature must be configured on Cisco WLC to prioritize multicast traffic over a wireless network?
Correct Answer: C
Vote an answer
Awireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings:
-72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received.
Which two commands achieve these settings? (Choose two.)
-72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received.
Which two commands achieve these settings? (Choose two.)
Correct Answer: A,B
Vote an answer
Which two parameters are needed to initialize Cisco MSE for network operations? (Choose two.)
Correct Answer: A,E
Vote an answer
A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAGconfiguration? (Choose four.)
Correct Answer: A,B,D,F
Vote an answer
0
0
0
10