Cisco 300-515 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 300-515
Exam Name/Title: Implementing Cisco Service Provider VPN Services
Certification Provider: Cisco
Corresponding Certification: CCNP Service Provider

Exam Questions: 87
Updated On: May 29, 2026

Question #28

Refer to the exhibit. Which statement describes the result of this BGP configuration?

A. R1 establishes an iBGP relationship with peer 192.168.1.1.

B. R1 operates using IPv4 and VPNv4 address families.

C. R1 establishes a VPNv4 eBGP relationship with neighbor 192.168.1.1.

D. R1 operates on IPv6 only because the bgp default ipv4-unicast command is missing.

Discussion 0

Correct Answer: A Vote an answer

Question #29

Which method can be used to discover targeted LDP neighbors dynamically when configuring VPLS between PE routers?

A. VPWS

B. BGP

C. VPLS peers under the VFI

D. BGP autodiscovery

Discussion 0

Correct Answer: D Vote an answer

Question #30

Refer to the exhibit. Which statement about this output is true?

A. The router IP 192.168.1.2 sent an implicit null, and the output is from the penultimate LSR.

B. The zero in the second column is the normal behavior of an egress router LSR.

C. The adjacent router is the egress LSR and has mpls ldp explicit-null configured.

D. The adjacent LSR router configured mpls label range 0.

Discussion 0

Correct Answer: C Vote an answer

Question #31

While configuring the VRF Selection feature, you get an error message after typing the below statement:
Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1
Which action caused this message?

A. an attempt to configure a VRF Selection table that does not exist

B. an attempt to remove a VRF Selection entry that does not exist

C. an attempt to configure a VRF instance on an interface that already has VRF Selection configured

D. the entry of an inconsistent IP address and mask for VRF Selection

Discussion 0

Correct Answer: B Vote an answer

Question #32

How does Layer 3 VPN traffic traverse an ISP network?

A. Devices on the network use GRE tunnels to move traffic between VRFs.

B. Devices on the network use MPLS labels to share VPN routes between P routers in the network.

C. Devices on the network use MPLS labels to move VPN traffic through the network.

D. Devices on the network use LSAs to share routes between P routers in the network.

Discussion 0

Correct Answer: C Vote an answer

Question #33

Refer to the exhibit. Router 1 is a P router in the ISP MPLS core.
A connected P router cannot generate an MPLS label for the router 1 loopback0 interface.
Which action resolves this issue?

A. The OSPF network type must be changed on loopback0 to point-to-point

B. A static route to null 0 must be added for the loopback interface and then static routes must be redistributed into OSPF

C. The loopback0 interface must be in OSPF area 0.

D. The network statement under the routing process must have a wildcard mask of 0 0.0 255.

Discussion 0

Correct Answer: D Vote an answer

Question #34

Refer to the exhibit. Which statement describes the result of this configuration?

A. R1 redistributes BGP routes into the OSPF process of VRF custabc as E1 routes.

B. R1 mutually redistributes routes between BGP 65001 and the OSPF process of VRF custabc.

C. R1 redistributes BGP routes into the OSPF process of VRF custabc as OIA routes.

D. R1 redistributes BGP routes into the OSPF process of VRF custabc as E2 routes.

Discussion 0

Correct Answer: A Vote an answer

Question #35

While troubleshooting an AToM L2VPN service, a network consultant notices that the AC Layer 2 encapsulations are different. Which action should the consultant take in order to make the MPLS L2VPN work?

A. nonrouted interworking setup to properly translate only the Layer 2 information from the AC

B. interworking IP configuration on the last PE router before label disposition

C. tag-rewrite on the ingress and egress PE router

D. interworking IP configuration on both the AC terminations on the PEs

Discussion 0

Correct Answer: D Vote an answer

Question #36

Which mechanism reduces the network flooding caused by host ARP learning behavior?

A. ARP suppression

B. BPDU guard

C. root guard

D. storm control

Discussion 0

Correct Answer: A Vote an answer

Download Free Cisco 300-515 Demo

Simply submit your e-mail address below to get started with our free demo of your Cisco 300-515 exam.