Latest Cisco 352-001 Actual Free Exam Questions & Community Discussion, Page 3

Question #31

For which two reasons do you choose L2TPv3 over other technologies for a VPN solution? (Choose two)

A. The VPN solution should tunnel Layer 2 frames and Layer 3 packets

B. The VPN solution requires multipoint Ethernet LAN service

C. The VPN solution should be industry standard.

D. The VPN solution does not contain MPLS on the network core.

E. The VPN solution should support Frame Relay to Ethernet pseudowrite connections.

Discussion 0

Correct Answer: C,D Vote an answer

Question #32

Refer to the exhibit A service provider has a requirement to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP- SW2 Which two ways to design this solution are true? (Choose two)

A. Forward LLD PDUs over the VPLS

B. Use upward maintenance endpoints on the SP switches

C. Enable unicast heartbeat messages to be periodically exchanged between MEPs

D. Enable Connectivity Fault Management on the SP switches

E. Forward E-LMI PDUs over VPLS

Discussion 0

Correct Answer: B,D Vote an answer

Question #33

You have been hired to redesign a network due to issues with congestion How will a router function if the QoS mechanism of congestion avoidance is integrated into the existing network design?

A. The router handles the possible build-up of congestion by using WRED

B. The router marks packets based on certain characteristics by using PBR

C. The router forces inbound and outbound traffic to stay within a defined profile by using rate limiting.

D. The router handles the overflow of traffic by using FIFO.

E. The router separates packets based on certain characteristics by using NBAR.

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #34

Which two design considerations must be considered when introducing FCoE into an existing network? (Choose two)

A. The existing network must support a MTU of 3280 bytes.

B. The FCoE QoS markings may overlap with call signaling QoS markings.

C. Twinaxial cabling can be used to transmit FCoE traffic between a server and its directly connected Ethernet switch, if is less than 10 meters away

D. Optical cabling is needed to transmit FCoE traffic between a server and its directly connected Ethernet switch.

E. All the servers in the data center must be retrofitted with Converged Network Adapters.

Discussion 0

Correct Answer: B,E Vote an answer

Question #35

You are designing the routing design for two merging companies that have overlapping IP address space. Which of these must you consider when developing the routing and NAT design?

A. Local to global NAT translation is done after routing

B. Local to global NAT translation is done before policy-based routing

C. Global to local NAT translation is done before routing.

D. Global to local NAT translation is done after policy-based routing.

Discussion 0

Correct Answer: C Vote an answer

Question #36

An enterprise company is attaching to a new Gigabit Ethernet based link from the local service provider. This connection must have a 150 Mbps committed information rate. For the design of this new service. Which QoS mechanism must be used to ensure low packet loss within the service provider network?

A. CBWFQ

B. Shaping

C. LLQ

D. Policing

Discussion 0

Correct Answer: B Vote an answer

Question #37

As part of the security protocol for your network design, you have designated that operator 82 is enabled for DHCP snooping. When option 82 is enabled, which information will be added to the DHCP request?

A. remote ID and circuit ID

B. switch MAC address and switch IP address

C. switch MAC address and VLAN module and port

D. switch IP address and VLAN, module and poet

Discussion 0

Correct Answer: A Vote an answer

Question #38

Which design benefit of bridge assurance is true?

A. It prevents switched traffic from traversing suboptimal paths on the network.

B. It prevents switch loops caused by unidirectional point-to-point link condition on Rapid PVST + and MST

C. It supposes a spanning-tee topology change upon connecting and disconnecting a station on a port

D. It allows small, unmanaged switches to be plugged into ports of access switches without the risk of switch loops.

Discussion 0

Correct Answer: B Vote an answer

Question #39

You want to add 900 VLANs to the existing 90 VLANs on a data center. Which two spanning-tree concerns must you consider? (Choose two)

A. The PVST+ increases CPU utilization

B. BPDU does not support 990 VLANs.

C. To add 990 VLANs to the switching hardware reserved VLANs requires you to use extended VLAN

D. The diameter of the STP topology is increased.

E. STP is increased by a factor of 10 convergence time.

Discussion 0

Correct Answer: A,E Vote an answer

Question #40

In a VPLS design solution, which situation indicates that BGP must be used instead of LDP in the control plane?

A. Pseudowire configuration overhead is reduced

B. There are no full-mesh pseudowire due to the route reflection feature of BGP

C. BGP supports VPLS interworking

D. MAC address learning scales better through BGP

Discussion 0

Correct Answer: A Vote an answer

Question #41

Which two design solutions ensure sub 50 msec of the convergence time after a link failure in the network? (Choose two)

A. BFD

B. IGP fast hello

C. minimal BGP scan time

D. Ti-LFA

E. MPLS-FRR

Discussion 0

Correct Answer: D,E Vote an answer

Question #42

Which two statements about MLD snooping are true? (Choose two)

A. AN MLD snooping querier election occurs when any MLD snooping querier goes down or if there is an IP address change on the active querier.

B. When MLD snooping is enabled, QoS is automatically enabled.

C. A VLAN can support multiple active MLD snooping queries, as long as each one is associated to a different multicast group.

D. When multiple MLD snooping queriers are enabled in a VLAN, the querier with the lowest IP address in the VLAN is elected as the active MLD snooping querier.

Discussion 0

Correct Answer: A,D Vote an answer

Question #43

Which three network management requirements are common practices in network design? (Choose three)

A. Validate data plane health, application and services availability with synthetic traffic

B. Ensure that all network devices have their clocks synchronized

C. Capture both ingress and egress flow-based packets. While avoiding duplications of flows

D. Look at average counters instead of instantaneous counters for inconsistent and bursty KPIs, such as CPU utilization and interface utilization.

E. Collect RMON poll information for future regression analysis

F. Collect SNMP poll information for future regression analysis

Discussion 0

Correct Answer: B,D,F Vote an answer

Question #44

Which statement about traffic shaping is true?

A. It regulates data transmission patterns into the network

B. It works by minimizing data transmission intervals

C. It enforces an upper limit on bursty data traffic

D. It separates data packets based on certain characteristics by using NBAR

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #45

Which three statements are correct for route filtering? (Choose three.)

A. Route filtering can create suboptimal routing, thus increasing latency in the network

B. The OSPF router LSA can be filtered with route maps so they are not installed on the OSPF database.

C. By default, EIGRP filters topology information at every hop in the network.

D. Inbound route filtering affects outbound traffic flow.

E. By default, EIGRP filters the reachability information at every hop in the network.

F. IS-IS filters reachability information from the Level 1 to Level 2 domain.

Discussion 0

Correct Answer: A,C,D Vote an answer

Cisco 352-001 Actual Free Exam Questions & Community Discussion

Download Free Cisco 352-001 Demo