Cisco 500-202 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 500-202
Exam Name/Title: Implementing Cisco Service Provider Mobile Unlicensed Small Cell Solutions
Certification Provider: Cisco
Corresponding Certification: Cisco Specialist

Exam Questions: 51
Updated On: May 30, 2026

Question #19

Which benefit is provided by link aggregation in the Cisco 8500 Series Controller?

A. high reliability by using eight 1 GbE ports

B. higher capacity and reliability by using two 10 GbE ports

C. higher capacity and reliability by using eight 1 GbE ports

D. higher reliability by using two 10 GbE ports

Discussion 0

Correct Answer: D Vote an answer

Question #20

In an architecture without an ISG, what is the policy control and enforcement function?

A. Cisco SGSN

B. Cisco eWAG

C. the wireless LAN controller

D. Cisco GGSN

Discussion 0

Correct Answer: D Vote an answer

Question #21

Which option is a requirement for a client when PMIPv6 is used in the Cisco Service Provider Wi-Fi environment?

A. The client must be configured to support IPv6 and be assigned an IPv6 address.

B. The client must run a dual-stack, that is, have both an IPv4 and an IPv6 address assigned to it.

C. The client must be connected to the MAG through an IPv4-over-IPv6 tunnel.

D. There are no special requirements for the client.

Discussion 0

Correct Answer: D Vote an answer

Question #22

Which two methods should you use to verify that PMIPv6 functionality has been properly configured and is operational? (Choose two.)

A. Verify that the IPv4 address that is assigned to the client is from the DHCP pool on the LM

B. Use show commands to verify the PMIPv6 tunnel and bindings on the MAG.

C. Perform an IPv6 ping from a client to the wireless controller.

D. Use the PMIPv6 tunnel test command on the Cisco eWAG.

Discussion 0

Correct Answer: A,B Vote an answer

Question #23

When you place a MAG on the Cisco WLC, which two pieces of LMA information are critical to creating a PMIPv6 tunnel? (Choose two.)

A. LMA IP address

B. DHCP option 82 information

C. NAI

D. MAC address of the Cisco WLC

Discussion 0

Correct Answer: A,C Vote an answer

Question #24

Which option is a session anchor point for a Cisco eWAG?

A. Cisco SGSN

B. Cisco SGW

C. Cisco PGW

D. Cisco GGSN

Discussion 0

Correct Answer: D Vote an answer

Download Free Cisco 500-202 Demo

Simply submit your e-mail address below to get started with our free demo of your Cisco 500-202 exam.