CompTIA PD1-001 Actual Free Exam Questions & Community Discussion
Which of the following occurs to the surface of the photoconductor during the erasing?
Correct Answer: A
Vote an answer
Which of the following components would be used for drive where precise RPM is critical?
Correct Answer: C
Vote an answer
When using a multimeter to check continuity to which of the following states should the printer be in?
Correct Answer: A
Vote an answer
A dislodged separation pawl in the fuser is MOST likely going to:
Correct Answer: C
Vote an answer
A technician is working on a multi-function device at a repair facility and identifies a failed part that needs to be replaced. The part is not in stock and will take three days for delivery. Which of the following is the BEST way for the technician to handle this situation?
Correct Answer: B
Vote an answer
Which of the following component types are used by scanners for capturing images?
(Select TWO).
(Select TWO).
Correct Answer: C,E
Vote an answer
After installing a new network printer a technician notices that a valid IP address has been automatically assigned to the printer. Which of the following would allow this to occur?
Correct Answer: B
Vote an answer
Which of the following is an accurate definition of gamut?
Correct Answer: A
Vote an answer
Which of the following should be done when a printed output is smearing? (Select TWO).
Correct Answer: A,E
Vote an answer
When troubleshooting a device, which of the following should be performed when photoconductors are removed?
Correct Answer: B
Vote an answer
During the photoconductor preparation stage, residual toner can be removed by which of the following?
Correct Answer: A
Vote an answer
0
0
0
10