Dell DSDSC-200 Actual Free Exam Questions & Community Discussion
There are several servers connected to the Storage Center through Fibre Channel (FC) fabrics using WWN zoning. The engineer has recently replaced a server's FC HB. This server can no longer connect to the Storage Center.
What is causing the problem?
What is causing the problem?
Correct Answer: B
Vote an answer
When replacing a defective SC4020 controller with a new controller, the engineer notices that the new controller does NOT fully initialize. The system runs SCOS version 6.5.30.
Which three actions should the engineer take? (Choose three.)
Which three actions should the engineer take? (Choose three.)
Correct Answer: C,D,E
Vote an answer
An administrator needs to replicate data to an off-site Storage Center. Data on both sides must always match The administrator must have the data sent to the remote system as soon as the data is written. If the communication to the remote system fails, ail writes to the local system must stop
Which option should the administrator choose to meet the requirements?
Which option should the administrator choose to meet the requirements?
Correct Answer: C
Vote an answer
During failover testing, an engineer finds that the iSCSI connection failed over properly when a physical link was disconnected. The FC connection did NOT failover when a physical link was disconnected.
Which configuration is causing this issue?
Which configuration is causing this issue?
Correct Answer: C
Vote an answer
Which characteristic of OLTP workloads needs to be considered when optimizing OLTP workloads on the
SC array?
SC array?
Correct Answer: C
Vote an answer
A local Storage Array replicates to a remote Storage Array. A problem occurs oil the local
Storage Array, which causes the engineer to failover to the remote Storage Array. Once the problem is fixed, the engineer needs to fail back to the local Storage Array. When the engineer tries to fail back to the local Storage Array. NO volumes are available to fail back
What is the cause of the problem?
Storage Array, which causes the engineer to failover to the remote Storage Array. Once the problem is fixed, the engineer needs to fail back to the local Storage Array. When the engineer tries to fail back to the local Storage Array. NO volumes are available to fail back
What is the cause of the problem?
Correct Answer: A
Vote an answer
A Storage Center runs in Legacy Port mode.
How should the Storage Center zone(s) be set up?
How should the Storage Center zone(s) be set up?
Correct Answer: D
Vote an answer
A client needs On Demand Data Progression to immediately move data from Tier 1 to Tier
2 when a replay is taken.
After enabling manual mode, which two attributes should the technician assign to a custom storage profile to meet this requirement? (Choose two.)
2 when a replay is taken.
After enabling manual mode, which two attributes should the technician assign to a custom storage profile to meet this requirement? (Choose two.)
Correct Answer: A,C
Vote an answer
0
0
0
10