Fortinet NSE7_EFW-7.2 Actual Free Exam Questions & Community Discussion

Exam Code/Number: NSE7_EFW-7.2
Exam Name/Title: Fortinet NSE 7 - Enterprise Firewall 7.2
Certification Provider: Fortinet
Corresponding Certification: NSE 7 Network Security Architect

Exam Questions: 82
Updated On: Jun 03, 2026

Question #37

Refer to the exhibit, which shows a routing table.

What two options can you configure in OSPF to block the advertisement of the 10.1.10.0 prefix? (Choose two.)

A. Configure a distribute-list-out

B. Remove the 16.1.10.C prefix from the OSPF network

C. Disable Redistribute Connected

D. Configure a route-map out

Discussion 0

Correct Answer: A,D Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #38

Refer to the exhibit, which shows device registration on FortiManager.

What can you conclude about the Spoke-1 and Spoke-2 configurations with respect to the information cond:
Modified (recent auto-updated)?

A. Spoke-1 and Spoke-2 are sharing the same security policy configuration and the same policy package.

B. On NGFW-A, the configuration was changed and spokes are wailing for an autoupdate.

C. On both Spoke-1 and Spoke-2, the configuration was changed directly on the FortiGate device, and the changes were automatically retrieved by the device database.

D. Based on the policy configuration on NGFW-1, the configuration on both spokes is modified and automatically updated.

Discussion 0

Correct Answer: B Vote an answer

Question #39

Refer to the exhibits, which contain the network topology and BGP configuration for a hub.
Exhibit A.

Exhibit B.

An administrator is trying to configure ADVPN with a hub and spoke VPN setup using iBGP. All the VPNs are up and connected to the hub. The hub is receiving route information from both spokes over iBGP; however the spokes are not receiving route information from each other.
What change must the administrator make to the hub BGP configuration so that the routes learned from one spoke are forwarded to the other spoke?

A. Configure the hub as a route reflector

B. Add a prefix list to the hub that permits routes to be shared between the spokes

C. Configure auto-discovery-sender on the hub

D. Enable route redistribution under config router bgp

Discussion 0

Correct Answer: C Vote an answer

Question #40

Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi- access network is true?

A. FortiGate first checks the OSPF ID to elect a DR.

B. Only the DR receives link state information from non-DR routers.

C. Non-DR and non-BDR routers send link state updates and acknowledgements to 224.0.0.6.

D. Non-DR and non-BDR routers form full adjacencies to DR only.

Discussion 0

Correct Answer: D Vote an answer

Question #41

Exhibit.

Refer to the exhibit, which contains an active-active toad balancing scenario.
During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.
What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?

A. Secondary virtual MAC port1

B. Secondary virtual MAC port1 then physical MAC port1

C. Secondary physical MAC port2 then virtual MAC port2

D. Secondary physical MAC port1

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #42

Refer to the exhibit, which contains a partial configuration of the global system.

What can you conclude from the output?

A. set check-protocol-header loose command enables hardware acceleration on this FortiGate device.

B. set av-failopen pass command instructs the FortiGate to offload all traffic that uses the antivirus proxy to NP.

C. set strict-d^rty-session-check enable command instructs the FortiGate to offload all dirty session traffic to its SPU

D. set memory-use-threshoId-extreme command instructs the FortiGate to disable hardware acceleration if the memory extreme threshold reaches 95%

Discussion 0

Correct Answer: A Vote an answer

Question #43

Which two statements about IKE vision 2 are true? (Choose two.)

A. It exchanges a minimum of four messages to establish a secure tunnel

B. It supports the XAuth protocol.

C. Phase 1 includes main mode

D. It supports the extensible authentication protocol (EAP)

Discussion 0

Correct Answer: A,D Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #44

Exhibit.

Refer to the exhibit, which contains a CLI script configuration on fortiManager. An administrator configured the CLI script on FortiManager rut the script tailed to apply any changes to the managed device after being executed.
What are two reasons why the script did not make any changes to the managed device? (Choose two)

A. CLI scripts must start with #!.

B. The commands that start with the # sign did not run.

C. Incomplete commands can cause CLI scripts to fail.

D. Static routes can be added using only TCI scripts.

Discussion 0

Correct Answer: B,C Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #45

Exhibit.

Refer to the exhibit, which contains a CLI script configuration on FortiManager.
An administrator configured the CLI script on FortiManager Which statement is true based on the script configuration?

A. The script successfully added a static route with gateway 10.20.121.2 on the manages device

B. The CLI scripts failed to execute because of an incomplete command

C. CLI scripts must start with # l.

D. The commands are missing d3_cmd at beginning

Discussion 0

Correct Answer: B Vote an answer

Download Free Fortinet NSE7_EFW-7.2 Demo

Simply submit your e-mail address below to get started with our free demo of your Fortinet NSE7_EFW-7.2 exam.