HP HPE6-A73 Actual Free Exam Questions & Community Discussion
Which concept is implemented using Aruba's dynamic segmentation?
Correct Answer: B
Vote an answer
An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?
What would cause this problem?
Correct Answer: D
Vote an answer
Examine the attached diagram
Two AOS-CX switches are configured for VSX at the access layer, where servers attached to them. An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been configured on the switches.
What is correct about access from the servers to the Core?
Two AOS-CX switches are configured for VSX at the access layer, where servers attached to them. An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been configured on the switches.
What is correct about access from the servers to the Core?
Correct Answer: C
Vote an answer
An administrator wants to implement a virtual switching technology that implements a single control-plane solution. Which S-CX switches would meet these criteria?
Correct Answer: A
Vote an answer
A network administrator is implementing a configuration plan in NetEdit. The administrator used NetEdit to push the configuration plan to the switch. Which option in the NetEdit planning section should the administrator select to save the configuration running on the switch to the startup-config?
Correct Answer: D
Vote an answer
An administrator is configuring BGP and has two connections to a service provider to two different local routers.
Which BGP metric should the administrator configure to influence which local router the service provider will use to reach certain routes?
Which BGP metric should the administrator configure to influence which local router the service provider will use to reach certain routes?
Correct Answer: B
Vote an answer
A network has an ABR that connects area 0 and 1. A network engineer configures a summarized route for area 0. The ABR is a designated router (DR) for the segment it uses to connect to area 1.
Which LSA type is assigned to this route when the summarized route is advertised into area 1 by the ABR?
Which LSA type is assigned to this route when the summarized route is advertised into area 1 by the ABR?
Correct Answer: A
Vote an answer
An administrator is supporting a network with the access layer consisting of AOS-CX 6300 and 6400 switches. The administrator needs to quickly deploy Aruba IAPs and security cameras in the network, ensuring that the correct QoS and VLAN settings are dynamically applied to the switch ports. Currently, switches are not configured to do device authentication, and no authentication server exists in the network.
Which AOS-CX feature should the administrator use to dynamically assign the policy settings to the correct switch ports?
Which AOS-CX feature should the administrator use to dynamically assign the policy settings to the correct switch ports?
Correct Answer: B
Vote an answer
0
0
0
10