Huawei H12-223-ENU Actual Free Exam Questions & Community Discussion

  • Exam Code/Number: H12-223-ENU
  • Exam Name/Title: HCIP-Routing&Switching-IEEP(Huawei Certified ICT Professional- Implementing Enterprise Network Engineering Project)
  • Certification Provider: Huawei
  • Corresponding Certification: HCNP-R&S
  • Exam Questions: 162
  • Updated On: Jul 13, 2026
Which of the following formulas is used to calculate availability?
Correct Answer: D Vote an answer
During unpacking and inspection, the device appearance is intact and all modules work properly after the first power-on. After the device continuously runs for 24 hours, a fault occurs on a card. This situation does not conform to DOA conditions.
Correct Answer: B Vote an answer
Which of the following tasks need to be completed during the planning stage of a project? (Multiple Choice)
Correct Answer: A,C Vote an answer
To improve Internet egress reliability, an enterprise uses multiple links to connect to different carrier networks. This mode requires attention to both the incoming and outgoing traffic paths. Otherwise, network quality may be affected.
Correct Answer: A Vote an answer
When the DHCP relay function is configured on a device, VLANIF interfaces connected to DHCP clients must be bound to a DHCP server group containing the IP address of the DHCP server.
Correct Answer: A Vote an answer
If you can ping the peer host successfully, which of the following methods is the most appropriate for subsequent troubleshooting?
Correct Answer: C Vote an answer
Which of the following functions is not achieved by formulating a project delivery process?
Correct Answer: D Vote an answer
During EBGP peer relationship troubleshooting, it is found that two directly connected devices set up connections using loopback interfaces. Therefore, the display current-configuration configuration bgp command is executed to check the configuration of peer ebgp-max-hop hop-count.
Which of the following statements is correct?
Correct Answer: B Vote an answer
During troubleshooting, you analyze and check the fault cause at the access layer, aggregation layer, and core layer in sequence.
Which of the following troubleshooting methods is used in this process?
Correct Answer: D Vote an answer
0
0
0
10