IBM P6040-014 Actual Free Exam Questions & Community Discussion

Exam Code/Number: P6040-014
Exam Name/Title: IBM SurePOS 500 Models 5x5 Technical Mastery
Certification Provider: IBM
Corresponding Certification: IBM Mastery

Exam Questions: 65
Updated On: Jun 01, 2026

Question #15

Which three functionsdoes Remote Management Agent v2 enable? (Choose three.)

A. inventory management

B. wake on ring

C. preboot execution

D. remote printing

E. software distribution

F. configuration management

Discussion 0

Correct Answer: A,E,F Vote an answer

Question #16

In order to preventelectrostatic discharge (ESD) damage when removing or replacing parts in the IBM SurePOS 5x5, which preliminary step should be taken before opening the device?

A. remove wool clothing to reduce ESD

B. wear rubber gloves to reduce ESD

C. connect an ESD wrist strap and cord

D. stand on an ESD treated rubber mat

Discussion 0

Correct Answer: C Vote an answer

Question #17

What are three applicable precautionary steps to handling static-sensitive components? (Choose three.)

A. when putting down static-sensitive components, do so on top of an anti-static bag, not on the system cover or metal table

B. lessen the amount of static electricity by limiting the amount of movement

C. stand with at least one foot on ananti-static mat when installing printed circuit boards

D. once the component is removed from the anti-static bag, install it immediately

E. keep one finger on the metal frame at all times

F. wear rubber gloves to reduce static electricity and prevent cuts from the sharp edges

Discussion 0

Correct Answer: A,B,D Vote an answer

Question #18

Why isit a good diagnostic measure to reset CMOS settings to the factory default?

A. It defragments the hard disk drive and reclaims wasted space.

B. It restores a corrupted CMOS.

C. It gives a view to the system before any software was installed.

D. It refreshes and compresses system memory.

Discussion 0

Correct Answer: B Vote an answer

Question #19

What is the starting point for diagnosing a problematic IBM SurePOS 5x5?

A. with the systemoff, reseat the DIMMs; power on the system

B. power on the system; pay particular attention to POST; make sure to observe the LED blinking and one beep beforethe system powers up

C. refer to the start up sequence listed in the User's Guide; power on and note any differences

D. attach a USB CD drive containing the IBM Diagnostics for POS Systems and Peripherals; power on the system; follow any corrective action

Discussion 0

Correct Answer: B Vote an answer

Question #20

Which two statements are true about "dual-channel memory enabled"technology? (Choose two)

A. It partitions a portion of the hard disk drive to be used as an additional memory cache.

B. It has two sets of memory slots (two each) on the system board.

C. It is the equivalent of having two pipelines to the processor rather than one.

D. It makes use of virtual RAM.

E. It doubles the capacity of feeding data to the processor.

Discussion 0

Correct Answer: C,E Vote an answer

Question #21

To visually determine if the IBM SurePOS 565 has a PC card installed in the PC card slot, where should a technician look?

A. with the touch screen facing the technician, rotate it back as far as it can go and then inspect on the bottom of the system

B. the lower left side of the system with the touch screen facing the technician

C. with the touch screen facing the technician, rotate it down as far as it can go and then inspect on the top of thesystem

D. the lower right side of the system with the touch screen facing the technician

Discussion 0

Correct Answer: B Vote an answer

Download Free IBM P6040-014 Demo

Simply submit your e-mail address below to get started with our free demo of your IBM P6040-014 exam.