Latest Avaya 3605 Actual Free Exam Questions & Community Discussion, Page 4

Question #40

By default the ERS 8000 is configured for warm standby. After installation of a new ERS solution with dual CPUs, which three actions need to be Perform on the ERS configuration to ensure high availability mode is enabled and will function correctly? (Choose three)

A. Set the high availability CPU boot flag to true.

B. Set the warm standby CPU hoot flag to false.

C. Save the boot.cfg conflg file and reset the switch to activate the changes.

D. Set the save to standby CPU boot flag to true.

E. Install the high availability license file.

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #41

A technician is configuring the core of a Converged Campus network, and is adding a backup-master configuration to an existing Virtual Router Redundancy Protocol (VRRP) configuration for a VLAN that extends to the edge switches. Which benefit is expected from the addition of backup-master?

A. reduced traffic on the uplink ports

B. reduced traffic on the Inter Switch Trunks (1ST)

C. reduces VRRP hello packets

D. redundant default gateways for host devices

Discussion 0

Correct Answer: B Vote an answer

Question #42

An Information Technology organization needs to
determine whether they should upgrade their existing Routing Switch (ERS) 8600 switches to release 5.0. Each chassis currently has both 8648GTR 8648TX modules. One of the features that the company requires is the ability to perform port mirroring on multiple ports per module
at a time.
What
should be done to meet
their port mirroring requirement when upgrading to software release 5.0?

A. Upgrade to ERS 8600 Release 5.0 without any hardware upgrade.

B. Replace the existing modules with 8648GTRS modules,

C. Replace the existing
8648TX modules
with ERS 8648TXE
for egress mirroring.

D. Recommend other means to capturing traffic.

Discussion 0

Correct Answer: B Vote an answer

Question #43

As stated in RFC
2338. (Virtual Router Redundancy Protocol) VRRP management problems can occur if the address used by the management station is used incorrectly. Which two statements describe how to avoid management problems? (Choose two)

A. A VRRP interface MUST accept packets addressed to the IP address (es) associated with the virtual router if it is the IP address owner (priority = 255)

B. A VRRP interface MUST accept packets addressed to the IP address (es) associated with the virtual router if it is not the IP address owner (priority = 255)

C. A VRRP interface MUST NOT accept packets addressed to the IP address (es) associated with the virtual router if it is not the IP address owner (priority = 255)

D. A VRRP interface MUST NOT accepts packets addressed to the IP address (es) associated with the virtual router if it is the IP address owner. (Priority=255)

Discussion 0

Correct Answer: A,C Vote an answer

Question #44

Which steps are initial steps required to configure the Ethernet Routing Switch (ERS) 8600 in a clustered basic core configuration? (Choose three.)

A. create the IST

B. configure SMLT

C. enables OSPF

D. create VLANs

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for EduDump members. You can sign-up / login (it's free).

Question #45

The edge has been configured; the core configuration can be verified. Which configuration is the last step in the verification process?

A. Ext CP limit configuration check

B. SLPP configuration check

C. MLT configuration check

D. VLACP configuration check

Discussion 0

Correct Answer: B Vote an answer

Question #46

Which commands will configure the labeled Ethernet ports appropriately?

A. Config Ethernet 3/1 enable- diffserv true config Ethernet 1/1 access- diffserv false

B. Config Ethernet 3/1 enable- diffserv true config Ethernet 1/1 access- diffserv true

C. Config Ethernet 3/1 enable- diffserv true config Ethernet 3/1 access- diffserv true

D. Config Ethernet 1/1, 3/1 enable- diffserv true config Ethernet 1/1 access- diffserv true

Discussion 0

Correct Answer: D Vote an answer

Question #47

The
IEEE 802.1aq virtualized service standard supports two
modes
of operation for the implementation of shortest path Bridging. Which mode is supported in the Avaya VENA Enterprise Fabric solution?

A. Shortest Path Bridging VID (SPBV)

B. Shortest Path Bridging Mac-In-Mac (SPBM)

C. Shortest Path Bridging SID (SPBS)

D. Provider link state bridging (PLSB)

Discussion 0

Correct Answer: A Vote an answer

Question #48

The trace level 9 3 command accomplish?

A. It captures BGP events at a terse level.

B. It captures RCC IP events at verbose level.

C. It captures packets copied to the CPU at a verbose level.

D. It shows CPU utilization.

Discussion 0

Correct Answer: C Vote an answer

Question #49

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS)
8648GTRS 10/100/1000 Ethernet I/O module left
LED -green Right LED -
flashing green. What is the status of the port?

A. The link speed is 1000 Mbps. and the port is passing traffic.

B. The link speed is 1000 Mbps, and the port is disabled

C. The link speed is 100 Mbps. and the port is passing traffic.

D. The link speed is 100 Mbps. and the port is disabled.

Discussion 0

Correct Answer: C Vote an answer

Question #50

A university campus network consists of an Ethernet Routing
Switch (ERS) 8000 and Ethernet
switches.
Recently
they implemented
Routed Split
Multi-Link Trunking (RSMLT) over a split Multi- Link Trunk (SMLT) configuration. What is the advantage of implementing RSMLT over SMLT?

A. RSMLT achieves better data distribution across the SMLT.

B. RSMLT extends fast failover benefits to the routed portion of the network.

C. RSMLT allows the addition new users in a separate building.

D. RSMLT increases the distance of the SMLT core.

Discussion 0

Correct Answer: B Vote an answer

Question #51

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Ethernet Routing Switch (ERS) 8000-based core. The technician has to configure VRF on the ERS 8000. Which statement represents the order for configuring a new VRF?

A. Create a new VLAN, add an IP address, create a VRF, and move the VLAN to the new VRF.

B. Create a VRF, add an IP address, create a new VLAN, and move the VLAN to the new VRF.

C. Create a VRF, create a new VLAN, add an IP address, and move the VLAN to the new VRF.

D. Create a VRF, create a new VLAN, move the VLAN to the new VRF, and add an IP address.

Discussion 0

Correct Answer: D Vote an answer

Question #52

Based on the command line output shown in the exhibit, how many Gigabit Ethernet ports are available on this Ethernet Routing Switch (ERS) 8600?

A. 24

B. 28

C. 16

D. 26

Discussion 0

Correct Answer: D Vote an answer

Avaya 3605 Actual Free Exam Questions & Community Discussion

Download Free Avaya 3605 Demo