Aruba ACMP_6.3 Actual Free Exam Questions & Community Discussion

Which of the statements below are TRUE regarding ARM's Spectrum Load Balancing feature? (Choose two)

When the controller is configured for Captive Portal and the user is only required to provide an email address for authentication, which option is configured in the GUI?

Which of the following licenses can be included in the licensing pool for centralized licensing? (Choose three)

Which ARM feature addresses the issue of sticky clients by moving clients to associate to APs with better 802.11 signal quality?

A customer has a remote AP deployment, where each remote AP has an IPSEC VPN tunnel with L2TP to the controller. 1 of the remote APs is stuck in the user table and hasn't yet transitioned to the AP active table in the controller. The customer suspects that the AP is not setting up its VPN connection successfully. Which of the following commands might be useful in troubleshooting this? (Choose three)

When configuring ports in the Controller wizard, which of the following are NOT configuration options? (Choose two)

An Aruba controller is configured with the correct IP address and gateway information and is connected to the corporate LAN via a core layer 2 switch. Control Plane Security is not enabled on the network. An access point is provisioned with AP name and group and connected to a different Layer 2 switch on the corporate LAN that has IP connectivity to the core layer 2 switch. The AP powers on and layer 2 connects to the network, but the wireless radios do not power on.
Which could cause this condition? (Choose two)

The reusable Aruba Controller wizards are accessible in what way?

In the above screen capture:

The administrator notes that most of the configuration options are grayed out and have no action.
What is the cause of the problem?

In an Aruba controller based system, the L3 mobility tunnel exists between the home agent and which other element?

(group8) #show ap arm history ap-name AP1
Interface :wifi0 ARM History
Time of Change Old Channel New Channel Old Power New Power Reason
2010-10-28 07:58:53 157+ 149+ 21 21 I 2010-10-28 07:52:06 149+ 157+ 21 21 M 2010-10-28 07:16:59 157+ 149+ 21 21 I
Interface :wifi1 ARM History
Time of Change Old Channel New Channel Old Power New Power Reason
2010-10-28 08:52:53 6 1 21 21 I
Referring to the output above. What can you conclude about AP1?

Exhibit: Referring to the diagram provided for this question, in which locations must you define the new data VLANs for wireless client traffic? (Choose two)