BICSI RCDD-002 Actual Free Exam Questions & Community Discussion
A campus backbone design linking two buildings requires that you install a high-fiber-count cable very quickly, using the conduit system provided. Cost is not so much an issue as urgency is to meet a service demand. Your first choice of fiber cable installation is to use:
Correct Answer: C
Vote an answer
You are designing a DAS system that has a requirement to supply both RF signal and power to the remote transceivers in the system. Which cable will provide the needed services for this application?
Correct Answer: A
Vote an answer
Within building automation hardware systems, there is a hierarchical system of micro processor based controllers. Which type of controller is used to provide limited port capacity for connection of sensors, support, and execution of DDC programs, and usually operates in stand alone mode?
Correct Answer: B
Vote an answer
At the end of the third week of a project, the actual cost of work performed is $7000 USd and the budgeted cost of work performed is $8000 USd. Which of the following is true?
Correct Answer: B
Vote an answer
From a 1000 ft (305 m) roll of optical fiber, how many MAXIMUM length centralized optical fiber cabling runs can be made?
Correct Answer: D
Vote an answer
In an industry where a high level of humidity is measured, which type of label should be used?
Correct Answer: C
Vote an answer
Exhibit:
The following diagram represents what type of CATV distribution system?
The following diagram represents what type of CATV distribution system?
Correct Answer: A
Vote an answer
Electrical power cables are usually routed above aerial cable in order to:
Correct Answer: A
Vote an answer
An outside plant (OSP) cable must be placed under a pipeline with two side by side pipe runs. The distance between the outside pipes is 6 m (20 ft). What is the length of the conduit required to facilitate the pipeline crossing?
Correct Answer: B
Vote an answer
0
0
0
10