CheckPoint 156-585 Actual Free Exam Questions & Community Discussion

You have configured IPS Bypass Under Load function with additional kernel parameters ids_tolerance_no_stress=15 and ids_tolerance_stress-15 For configuration you used the *fw ctl set' command After reboot you noticed that these parameters returned to their default values What do you need to do to make this configuration work immediately and stay permanent?

Select the technology that does the following actions
- provides reassembly via streaming for TCP
- handles packet reordering and congestion
- handles payload overlap
- provides consistent stream of data to protocol parsers

Joey is configuring a site-to-site VPN with his business partner. On Joey's site he has a Check Point R80.10 Gateway and his partner uses Cisco ASA 5540 as a gateway.
Joey's VPN domain on the Check Point Gateway object is manually configured with a group object that contains two network objects:
VPN_Domain3 = 192.168.14.0/24
VPN_Domain4 = 192.168.15.0/24
Partner's site ACL as viewed from "show run"
access-list JOEY-VPN extended permit ip 172.26.251.0 255.255.255.0 192.168.14.0 255.255.255.0 access-list JOEY-VPN extended permit ip 172.26.251.0 255.255.255.0 192.168.15.0 255.255.255.0 When they try to establish VPN tunnel, it fails. What is the most likely cause of the failure given the information provided?

Where do Protocol parsers register themselves for IPS?

Check Point Threat Prevention policies can contain multiple policy layers and each layer consists of its own Rule Base Which Threat Prevention daemon is used for Anti-virus?

You need to run a kernel debug over a longer period of time as the problem occurs only once or twice a week. Therefore, you need to add a timestamp to the kernel debug and write the output to a file but you can't afford to fill up all the remaining disk space and you only have 10 GB free for saving the debugs. What is the correct syntax for this?

Which command can be run in Expert mode lo verify the core dump settings?

If the cpsemd process of SmartEvent has crashed or is having trouble coming up. then it usually indicates that___________.

What is the kernel process for Content Awareness that collects the data from the contexts received from the CMI and decides if the file is matched by a data type?

Jenna has to create a VPN tunnel to a CISCO ASA but has to set special property to renegotiate the Phase 2 tunnel after 10 MB of transferee1 dat a. This can not be configured in the smartconsole, so how can she modify this property?