Cisco 300-430 Actual Free Exam Questions & Community Discussion

An engineer is planning an image upgrade of the WLC, and hundreds of APs are spread across remote sites with limited WAN bandwidth. The engineer must minimize the WAN utilization for this upgrade. Which approach must be used for the AP image upgrade?

Refer to the exhibit. An engineer needs to configure location services in an office. The requirement is to use FastLocate and achieve higher locations refresh rates. Which location- based technique should be implemented?

An engineer must control administrative access to the WLC using their Active Directory without being concerned about RBAC after the admin user is authenticated. Which two features does the engineer configure to accomplish this task? (Choose two.)

What is characteristic of multicast mode that affects the wireless network when configured on a Cisco WLC?

An engineer must provide a graphical report with summary grouped data of the total number of wireless clients on the network Which Cisco Prime Infrastructure report provides the requited data?

Drag and Drop Question
A wireless engineer wants to schedule monthly security reports in Cisco Prime infrastructure.
Drag and drop the report the from the left onto the expected results when the report is generated on the right.

A WLC must be configured to allow multiple mDNS profiles based on a user authentication profile configured in Cisco ISE. Which WLAN setting must be configured?

An engineer is setting up a new unique NAD on a Cisco ISE. Which two parameters must be configured? (Choose two.)

An engineer is using Cisco Prime Infrastructure reporting to monitor the state of security on the WLAN. Which output is produced when the Adaptive wIPS Top 10 AP report is run?

A network engineer has been hired to perform a new MSE implementation on an existing network. The MSE must be installed in a different network than the Cisco WLC. Which configuration allows the devices to communicate over NMSP?

An employee with administrative rights has a Cisco OEAP at home. The employee must add an SSID to connect personal devices. Which two actions enable the employee to access the AP configuration? (Choose two.)

An engineer is configuring the maps on the Cisco Prime Infrastructure, but clients fail to show up on the maps. Which two actions are needed to complete this configuration? (Choose two.)

A municipality customer uses a Cisco 5520 Series Wireless Controller for the wireless network.
The customer intends to move the depot of its stores from using legacy bespoke voice-over-Wi-Fi handsets to a VoIP software package running on 5 GHz-capable laptops, tablets, and smartphones. Bluetooth headsets will be used for any voice communication on any data device.
Assuming that a suitable RF site survey for 5 GHz has already been carried out, which two configuration settings ensure the best possible voice experience? (Choose two.)

Refer to the exhibit. An administrator sees interferers that cause connectivity issues in the
2.4GHz band. The DCA cycle on the Cisco Catalyst 9800 Series wireless controller runs every six hours for this band. The RF environment is dynamic on that floor, so the APs must change channels when a certain level of interference is detected. Which feature should be enabled to manage the interference?