Cisco 600-601 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 600-601
Exam Name/Title: Managing Industrial Networks with Cisco Networking Technologies
Certification Provider: Cisco
Corresponding Certification: Cisco Specialist

Exam Questions: 64
Updated On: Jun 03, 2026

Question #15

With a Cisco IE 2000 switch, what does a power status LED indicate when it is solid green?

A. Power is present on the associated circuit, but there is no correlation to whether the system is operating normally.

B. The system is operating normally, but power is not necessarily present on the associated circuit.

C. Power is not present on the associated circuit and the power supply alarm is configured.

D. Power is present on the associated circuit and the system is operating normally.

E. The power status LED does not show solid green.

Discussion 0

Correct Answer: D Vote an answer

Question #16

What is the most critical step to perform when you are using optical fiber connectors?

A. Lightly sand with cloth prior to mating.

B. Immerse in alcohol prior to use.

C. Cover with dust caps when not in use.

D. Blow off and carefully wipe down with a tissue before and after each use.

Discussion 0

Correct Answer: C Vote an answer

Question #17

What do deflections indicate to the time domain reflectometer user?

A. Do not connect live circuit cables to the input of the time domain reflectometer. Connect the cable that is being tested to the cable connector on the front panel of the time domain reflectometer.

B. They indicate splices, water in the cable, split pairs, and discontinuities or faults.

C. They are used to select the I/O impedance of the time domain reflectometer. You can select 50, 75, 95, or 125? impedances.

D. Upward deflections indicate high-impedance mismatches or opens, and downward deflections indicate shorts or low-impedance mismatches.

Discussion 0

Correct Answer: D Vote an answer

Question #18

What is a reason to use privileged EXEC mode on an industrial switch?

A. to change terminal settings

B. to configure VLAN parameters

C. to verify commands that you have entered

D. to configure parameters that apply to the entire switch

Discussion 0

Correct Answer: C Vote an answer

Question #19

Which two reasons make mesh bonding systems most effective? (Choose two.)

A. cover wide areas

B. most cost-effective approach

C. create equipotential grounding systems

D. provide additional strength to floor structures

E. provide low-impedance noise-equalizing paths

Discussion 0

Correct Answer: C,E Vote an answer

Question #20

What are two symptoms of duplex mismatch? (Choose two.)

A. The half-duplex side sees frame sequence errors or runt frames.

B. Speed is seen equally slow in both directions.

C. Communication is slow and locks up.

D. Ping does not return from one direction versus the other direction.

E. The full-duplex side sees CRC errors.

Discussion 0

Correct Answer: A,C Vote an answer

Question #21

An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?

A. Use the switchport protected command to have the MAC addresses added to the configuration.

B. Enable port security and use the keyword sticky.

C. Set the switchport mode to trunk and save the running configuration.

D. Use the no switchport port-security command to allow MAC addresses to be added to the configuration.

Discussion 0

Correct Answer: B Vote an answer

Download Free Cisco 600-601 Demo

Simply submit your e-mail address below to get started with our free demo of your Cisco 600-601 exam.