Cisco 600-601 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 600-601
Exam Name/Title: Managing Industrial Networks with Cisco Networking Technologies
Certification Provider: Cisco
Corresponding Certification: Cisco Specialist

Exam Questions: 64
Updated On: Jun 03, 2026

Question #22

Which characteristic causes multimode fiber-optic cable to differ from single mode?

A. a wider variety of available connector types

B. shorter maximum network segment length for a given bandwidth

C. use outdoors as well as indoors

D. by allowing multiple network services in the same cable

Discussion 0

Correct Answer: B Vote an answer

Question #23

For which three issues should fiber-optic network segments be tested? (Choose three.)

A. attenuation

B. jitter

C. tensile stress

D. length

E. polarity

F. near-end crosstalk

Discussion 0

Correct Answer: A,D,E Vote an answer

Question #24

Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?

A. 255.255.255.192 and /25

B. 255.255.255.248 and /28

C. 255.255.255.224 and /26

D. 255.255.255.240 and /16

E. 255.255.255.240 and /28

F. 255.255.255.248 and /27

Discussion 0

Correct Answer: E Vote an answer

Question #25

Which option allows an EtherNet/IP I/O device to be safely installed where it is subject to water immersion?

A. The device is rated IP20 and immersed to 10 m.

B. The device is rated IP67 and a power cordset is used.

C. The device is rated IP20 and the power wiring is installed securely to the terminal block.

D. The device is rated IP67 and immersed to 10 m.

Discussion 0

Correct Answer: B Vote an answer

Question #26

With a Cisco IE 2000 switch, what does a port status LED indicate when it is solid green?

A. The port is sending or receiving data.

B. No link is present.

C. There is a link fault.

D. A link is present.

E. The port is not forwarding.

Discussion 0

Correct Answer: D Vote an answer

Question #27

In which two ways could you minimize the impact of monitoring an industrial network? (Choose two.)

A. Send random messages to a device and see what the response is.

B. Use an industrial-network-grade IDS-IPS system.

C. Make a copy of all the network traffic and analyze it offline.

D. Do frequent ping sweeps to industrial devices to check for their proper operations.

Discussion 0

Correct Answer: B,C Vote an answer

Question #28

Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?

A. link cost

B. hop count

C. link delay

D. administrative distance

E. link bandwidth

Discussion 0

Correct Answer: D Vote an answer

Download Free Cisco 600-601 Demo

Simply submit your e-mail address below to get started with our free demo of your Cisco 600-601 exam.