EMC D-PE-OE-01 Actual Free Exam Questions & Community Discussion

A new Dell customer is ordering servers that have very specific firmware dependencies. Any replaced parts of the same type must match the replaced original part identically. The procedure must be as simple as possible with minimal risk.
What action should a technician take to accomplish this goal?

A technician has received a new server with 5 drives and needs to configure the drives into a specific configuration as provided by the administrator.
The administrator will also add additional disks as separate raid arrays at a later date.
- Drive 0 is passed through to the OS (to be managed by the OS)
- Drives 1-3 as a RAID 5 with drive 4 as a hot spare just for this newly created RAID 5 How should the technician do this in the PERC BIOS?

Where is the LCD panel located on a Dell PowerEdge 16G server?

A technician has the ISO image of an OS that they need to install on a server in a remote location. They are already logged into the iDRAC.
How should the technician install the OS?

A technician is sent on-site to troubleshoot a server that reports errors during POST when rebooted. The LCD is amber. The error message is as shown: correctable memory error rate exceeded for DIMM B4 The server has a limited maintenance window. The technician needs to troubleshoot efficiently.
Which step should the technician take to troubleshoot?

How can a technician know whether IDRAC9 System Lockdown mode is enabled?

Which operation should a technician perform to ensure configuration recovery if a server must be physically replaced?

Which server security feature verifies the cryptographic signatures of the UEFI driver in Dell EMC PowerEdge 14G and 15G servers?

A new Dell EMC PowerEdge server will be deployed in a branch office that does not have a good server cooling system. A Dell EMC Fresh Air system that can handle operating temperatures up to 45° C will be used.
What is required for the Fresh Air system to operate correctly?

A technician needs to add a server as a host to an existing VMware environment. The server has 2x 1Gb LOM ethernet ports and a 4-port 1Gb Broadcom NIC.
The 2 LOM ports are teamed to be used as SAN connections. All active data and management traffic should utilize the 4x 1Gb ports on the Broadcom NIC. The technician needs to achieve management and data redundancy at the hardware level to handle a single port failure.
What is the most effective way to meet this requirement?

A technician needs to configure the Lifecycle Controller network settings with a static IP address. A limited number of static IP addresses are available for use.
Which previously assigned IP address can also be used for the Lifecycle Controller?

A PowerEdge R740 server has a BOSS subsystem installed with two SSDs. A technician needs to configure the SSDs as a RAID 0 virtual disk and then load the operating system onto the BOSS SSDs.
However, the technician is unable to create the RAID 0 virtual disk.
What is the issue?

You are in a dark site with a PowerEdge server that shows an amber light. iDRAC Is not configured for network access but the OS is installed and has RACADM for access to the iDRAC card. What RACADM command can be used to help identify the cause of the amber light?

A server is being up as a VMware ESXi host. A technician needs to install the OS on an internal SD card. They install the SD card. However, during OS installation, the SD card is not visible.
What should the technician do to fix the issue?