HP HPE7-A01 Actual Free Exam Questions & Community Discussion

What is a primary benefit of BSS coloring?

Which standard supported by some Aruba APs can enable a customer to accurately locate wireless client devices within a few meters?

You are doing tests in your lab and with the following equipment specifications:
AP1 has a radio that generates a 17 dBm signal.

AP2 has a radio that generates a 9 dBm signal.

AP1 has an antenna with a gain of 8 dBi.

AP2 has an antenna with a gain of 12 dBi.

The antenna cable for AP1 has a 2 dB loss.

The antenna cable for AP2 has a 3 dB loss.

What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for AP1?

With a CX switch, how would you use loopback 0 as a primary interface for the TFTP protocol?

When setting up an AOS-CX VSX pair, which information does the Inter-Switch Protocol synchronize in the configuration created?

Which component is used by the Aruba Network Analytics Engine (NAE)?

Which component is used by the HPE Aruba Networking Analytics Engine (NAE)?

What does the 802.3bz standard describe?

Your manufacturing client is deploying twenty headless scanners in their warehouse. These new devices do not support 802.1X authentication.
How does the gateway determine the device's role and VLAN derivation-rules when using MPSK Local?

A client is connecting to 802.1X SSID that has been configured in tunnel mode with the default AP- group settings.
After receiving Access-Accept from the RADIUS server, the Aruba Gateway will send Access- Accept to the AP through which tunnel?

Drag and Drop Question
What is the order of operations for Key Management service for a wireless client roaming from AP1 to AP2?

Your customer is having issues with Wi-Fi 6 clients remaining connected to poor-performing APs when less utilized APs offering better SNR are available.
Which technology should you implement?

How do you allow a new VLAN 200 for downstream access switch with VSX pair using VSX LAG?

You are doing tests in your lab and with the following equipment specifications:
* AP1 has a radio that generates a 10 dBm signal
* AP2 has a radio that generates a 11 dBm signal
* AP1 has an antenna with a gain of 9 dBi
* AP2 has an antenna with a gain of 12 dBi
* The antenna cable for AP1 has a 2 dB loss
* The antenna cable for AP2 has a 3 dB loss
What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for APT?

Which of the following can cause wired network connectivity issues? (Select two.)