HP HPE7-A01 Actual Free Exam Questions & Community Discussion

Drag and Drop Question
Select the Aruba stacking technology matching each option (Options may be used more than once or not at all.)

A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus. Which technology minimizes flooding so the legacy application can work efficiently?

You are doing tests in your lab and with the following equipment specifications:
- AP1 has a radio that generates a 20 dBm signal
- AP2 has a radio that generates a 8 dBm signal
- AP1 has an antenna with a gain of 7 dBI.
- AP2 has an antenna with a gain of 12 dBI.
- The antenna cable for AP1 has a 3 dB loss
- The antenna cable for AP2 has a 3 dB loss.
What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for AP1?

On AOS-10 Gateways, which device persona is only available when configuring a Gateway-only group?

When configuring UBT on a switch what will happen when a gateway role is not specified?

A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network. The access switches are AOS-CX switches.
What command should the administrator use to examine information on which role the guest user has been assigned?

What steps are part of the Key Management workflow when a wireless device is roaming from AP1 to AP2? (Choose two.)

By default, Best Effort is higher priority than which priority traffic type?

You need lo have different routing-table requirements with Aruba CX 6300 VSF configuration.
Assuming the correct layer-2 VLAN already exists, how would you create a new OSPF configuration for a separate routing table?

What are key differences between 802.11 wireless and 802.3 Ethernet? (Select two.)

In AOS-10, which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations? The wired host ingress traffic arrives on a trusted port.

With Aruba CX 6300, how do you configure ip address 10.10.10.1 for the interface in default state for interface 1/1/1?

You are proposing new CX 8360 VSX switches to replace a customer's existing core switches.
The customer is concerned about the possibility of a split-brain scenario between the VSX pair.
How is the VSX pair affected when the ISL is down and keepalive is down?

Which network components communicate using the RADIUS protocol for authentication and accounting?

A network engineer recently identified that a wired device connected to a CX switch is misbehaving on the network. To address this issue, a new HPE Aruba Networking ClearPass policy has been put in place to prevent this device from connecting to the network again.
Which two steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Choose two.)