Huawei H12-811_V2.0 Actual Free Exam Questions & Community Discussion

  • Exam Code/Number: H12-811_V2.0
  • Exam Name/Title: HCIA-Datacom V2.0
  • Certification Provider: Huawei
  • Corresponding Certification: HCIA-Datacom
  • Exam Questions: 175
  • Updated On: Sep 27, 2026
Assume that the IPv6 address of GE0/0/0 on R1 is 2001:db8:12::1/64. Which of the following is the solicited-node multicast address of this IPv6 address?
Correct Answer: C Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
The emergence of AI poses new requirements on data center networks. To meet AI computing requirements, a high-speed intelligent computing data center network with zero packet loss needs to be constructed. Which of the following statements are false about the requirements and solutions of intelligent computing data center networks? (Select all that apply)
Correct Answer: B,C Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
In the centralized network architecture (WAC + Fit AP), Fit APs must go online before the WAC can manage and control them. Which of the following statements are true about the AP onboarding process? (Choose all that apply.)
Correct Answer: A,B,C,D Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
The essence of communication is the transmission and exchange of information between two or more points. The three elements of communication are the sender, content, and transmission channel of the information. The receiver of the information is not included among these elements.
Correct Answer: B Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
On the campus network shown in the figure below, the core switch Core1 functions as a Layer 3 gateway and as a DHCP server to dynamically assign IP addresses to AP1, PC1, PC2, and PC3.
The network below Core1 is a Layer 2 network. WAC1 and R1 are connected to Core1 at Layer
3. AP1 goes online through VLAN 100. The wireless service VLAN is VLAN 101, and the wired service VLANs for PC2 and PC3 are VLAN 102 and VLAN 103, respectively. Additionally, the direct forwarding mode is used for wireless traffic forwarding. If no additional VLANs are allowed on device interfaces, which of the following VLANs must be allowed on GE1/0/1 of ACC1? (Select all that apply)
Correct Answer: B,C,D Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
FILL BLANK
On the switched network shown in the figure, STP is enabled on all devices. SW1 is the root bridge. The port costs are shown in the figure. Other parameters retain the default values. After the network is stable, the RPC value from SW5 to the root bridge is _____. (Enter only digits.)
Correct Answer:
60
Explanation:
SW1 is the root bridge, so SW5's root path cost is calculated by selecting the lowest-cost path to SW1 through its neighbors.
SW5 has two possible paths:
Through SW4: SW5 → SW4 has a cost of 10. From SW4 to SW1, the lowest cost path is the direct link with cost 50. So total = 10 + 50 = 60.
Through SW3: SW5 → SW3 has a cost of 50. From SW3 to SW1, the best path is 40 (direct or via SW2), so total = 50 + 40 = 90.
The minimum path cost is 60, so SW5's RPC is 60.
On the network shown in the figure, R1 and R2 are directly connected through a physical link.
When the link is normal, R1 can ping the IP address of R2's interface.
Correct Answer: B Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
On a small WLAN shown in the figure, SW2 acts as a DHCP server to assign IP addresses to STAs, and the user data forwarding mode is direct forwarding. Which of the following traffic paths is used for a STA accessing the Internet after connecting to the WLAN through AP1?
Correct Answer: C Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
PC1 and PC2 are connected to the same switch, but they cannot learn each other's ARP information. This may be caused by incorrect VLAN configuration on the switch.
Correct Answer: A Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
When planning IPv4 addresses for a campus network, which of the following methods can you use to assign an IP address to the interface connecting the campus egress device to the WAN?
(Choose all that apply.)
Correct Answer: A,B,D Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
When a Huawei device functions as an SSH client to log in to another network device for the first time, the ssh client first-time enable command must be run to enable the first-time login function of the SSH client. Otherwise, the login fails.
Correct Answer: B Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
On a small WLAN shown in the figure, the WAC acts as a DHCP server to assign IP addresses to APs and STAs. The management VLAN is 100, the service VLAN is 110, and the user data forwarding mode is tunnel forwarding. Which of the following is the correct configuration for the switch and WAC interfaces?
Correct Answer: C Vote an answer
Explanation: Only visible for EduDump members. You can sign-up / login (it's free).
0
0
0
10