Oracle 1z1-404 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 1z1-404
Exam Name/Title: Oracle Communications Session Border Controller 7 Basic Implementation Essentials
Certification Provider: Oracle
Corresponding Certification: Session Border Control

Exam Questions: 70
Updated On: Jul 12, 2026

Question #1

You are configuring steering pools. After executing the done command, you get this error message:
error 409 saving configuration SteeringPool.
Identify the cause ofthe error.

A. The realm-id parameter value of the steering-pool refers to a realm-config element that already exists in the configuration.

B. The realm-id parameter value of the steering-pool refers to a realm-config element that does not exist in the configuration.

C. Another steering-pool configuration element with same ip-address and realm-id but with different start-port and end-port parameters values already exists in the configuration.

D. The ip-address parameter of the steering-pool has the same value as the address parameter of a sip-port configuration element.

E. Another steering-pool configuration element with same ip-address, realm-id, start-port, and end-port parameters values already exists in the configuration.

Discussion 0

Correct Answer: C Vote an answer

Question #2

You are configuring a network interface to enable the Session Border Controller to use the interface for signaling and media.
Identify two valid configuration steps for supporting VLAN 12 (Choose two.)

A. Navigate to the phy-interface configuration element and configure the hip-id parameter.

B. Navigate to the network-interface configuration element and configure the name parameter.

C. Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

D. Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

E. Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

Discussion 0

Correct Answer: A,E Vote an answer

Question #3

Which three statements are true about the bootloader? (Choose three.)

A. It reads the imagefile

B. It looks at the boot parameters

C. It is a Windriver's VxWork product

D. It decompresses the image file and loads it into the main RAM

E. It is based on Linux

Discussion 0

Correct Answer: A,B,D Vote an answer

Question #4

Which statement is true about Session Border Controller architectures andrealm bridging?

A. The Access-backbone architecture focuses on the border point between two backbone realms.

B. The Hosted NAT Traversal (HNT) architecture focuses on the border point between two different service provider networks, both in the home realm.

C. The Hosted IP architecture focuses on the border point between one enterprise network realm and one service provider network realm.

D. The Gateway architecture Focuses on the border point between one enterprise network realm and one service provider network realm.

E. The Peering architecture focuses on the border point between two different service provider networks and theirrealms.

Discussion 0

Correct Answer: C Vote an answer

Question #5

How doesthe Session Border Controller ensure that a pinhole is kept open for persistent communication to a SIP endpoint behind a NAT device?

A. by changing the expires= parameter to a defined value in 200 OK responses to
REGISTERs

B. by changing the expires= parameter to a defined value in 200 OK responses to INVITEs

C. by sending Address Resolution Protocol (ARP) requests at a defined frequency

D. by issuing PINGs to the endpoint's NAT address

E. by sending messages at a defined frequency

Discussion 0

Correct Answer: C Vote an answer

Question #6

You are adding peers to a Policy-Based Realm Bridging (PBRB) configuration.
Which two configuration steps, among others, are required? (Choose two.)

A. Navigate to the session-router configuration branch and configure the local-policy configuration element.

B. Navigate to the media-manager configuration branch and configure the realm-config configuration element.

C. Navigate to the session-router configuration branch and configure the sip-nat configuration element.

D. Navigate to the session-router configuration branch and configure the sipd-address configuration element.

E. Navigate to the media-manager configuration branch and configure the access-control configuration element.

Discussion 0

Correct Answer: B,E Vote an answer

Question #7

Which action triggers the 180 Ringing response in a User Agent Client (UAC)?

A. the establishment of a SIP session

B. the generation of a remote ring-back tone

C. the generation of a local ring-back tone

D. the termination of a SIP session

E. the subscription to a SIP presence service

Discussion 0

Correct Answer: C Vote an answer

Download Free Oracle 1z1-404 Demo

Simply submit your e-mail address below to get started with our free demo of your Oracle 1z1-404 exam.