Avaya 6101.1 Actual Free Exam Questions & Community Discussion

Exam Code/Number: 6101.1
Exam Name/Title: Avaya Ethernet Routing Switch Implementation Exam
Certification Provider: Avaya
Corresponding Certification: Avaya Specialist

Exam Questions: 70
Updated On: Aug 12, 2026

Question #1

A technician has installed a license file on the Ethernet routing switch (ERS) 8800 and rebooted, but cannot configure the associated licensed features. it has been determined that license did not load properly at booyup time.
Which two must be verified?

A. The license file has .dat extension.

B. The license filename contains valid characters.

C. The appropriate license level has been obtained.

D. The switch is at the current release.

E. The license file is stored in the flash directory

Discussion 0

Correct Answer: A,B Vote an answer

Question #2

In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, not green. What does this mean?

A. The port is set to operate at 100 Mbps.

B. It indicates that the port is administratively disabled.

C. It indicates that there is a transmit fault.

D. The port is set to operate at 10 Mbps.

Discussion 0

Correct Answer: B Vote an answer

Question #3

Confirm that RSMLT will work on a set of VLANs. Which network design aspect should be considered?

A. Router 1 always owns the network.

B. RSMLT is enabled on all SMLT VLANs.

C. RSMLT is enabled on the VLAN group.

D. RSMLT is enabled on each SMLT VLAN on which the function is required

Discussion 0

Correct Answer: D Vote an answer

Question #4

A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly connected without intermediary WAN transport devices
What are two key configuration tasks? (Choose two)

A. For the 1ST links, configure the long timeout value

B. For the SMLT links, configure the long timeout value

C. Configure all links to use a unique reserved multicast MAC address for VLACP messages

D. configure all links to use the default multicast MAC address for VLACP messages

Discussion 0

Correct Answer: A,C Vote an answer

Question #5

A technician is implementing a new network that contains eight Ethernet routing switch (ERS) 8600 switches and uses advanced features.
Where are two possibilities for generating license? (Choose two)

A. one advanced feature license for the network

B. one multi-chassis license using multiple MAC addresses

C. one premier feature license for the network

D. one site license per ERS 8600

E. one individual advanced feature license for each ERS 8600 chassis

Discussion 0

Correct Answer: A,D Vote an answer

Question #6

A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast
-
Sparse Mode (PIM-SM) Which licensing requirement applies?

A. the PIM-SM is already covered by the existing advanced feature license

B. the PIM-SM is included m the base license with release 6.2

C. the PIM-SM con only be licensed on ERS 5510 models

D. A Premier license is needed

Discussion 0

Correct Answer: B Vote an answer

Question #7

After experiencing issues with XFPs, the show sys pluggable-optical-modules into CLI command is used to find that the switch does not recognize the XFPs.
Which other method can be used to view the XFP compatibility?

A. Check for port alarms

B. select Edit, port, General, DDI/SFP from the Enterprise Device Manager to see the XFP port specifics_

C. Show DWDM-XFP {detail}

D. Config sys set pluggable-optical-module. Info

Discussion 0

Correct Answer: B Vote an answer

Download Free Avaya 6101.1 Demo

Simply submit your e-mail address below to get started with our free demo of your Avaya 6101.1 exam.